Lifting Hydraulic Jack for MTI-MSK-110 Replacement, MTI-MSK110-JACK Carbon Substrate & Foam

Lifting Hydraulic Jack for MTI-MSK-110 Replacement, MTI-MSK110-JACK Carbon Substrate & FoamSpecification: TYPE: Hydraulic Press for MTI MSK 110 Replacement, Jack Plunger Diameter 38 mm Recommended Pressure for coin cell 50 kg cm2 (kilogram per square centimeter) 711. 2 psi (pound per square inch) Status: Only Provide for current customers' replacement. Net Weight 9 lbs Dimensions of Shipment 8" x 8" x 6" Operation Instructions

Resistivity:                     0

Carbon Coated Cu         Alumina Coated Separator           Others

Doping density (Fe):  ~5E17 by SIMS

Web material

Composition:    Ge single crystal

you may need to put Spring/Spacer in between this case and anode

8 MPa (Air Compressor is not included

8 pt 0 2 MicrosoftInternetExplorer4 /* Style Definitions */ table

Mobility                                       9000 cm2/V

The full diamond sintered blade is suitable for low-speed cutting ( under 1000 RPM) of oxide single crystals or any brittle crystals

at extra cost

Doping:                               Sn- doped